Hi, I installed the new v7.3.x.r4824 FW and I have the following problem:
I can't access the HDD plugged to the POHD's USB from my PC - it reports "The network path was not found".
NAS is activated and I can copy files from my PC to POHD using the POHD's copy function. I configured a static IP for POHD (10.0.0.2).

I did the following just after copying some movies using POHD's copy function:
1) I pressed the POHD's remote Home key (I mean I switched to POHD's menu) then I went to my PC
2) I opened the command promt (cmd) and I tried "ping 10.0.0.2" -> OK
3) I tried to open \\10.0.0.2 (from Start -> Run) -> it reports "The network path was not found"
4) I tried to find POHD share using "My Network Places" -> I found only my PC
5) I tried to access "usb1 on Samba 3.0.23c (10.0.0.2)" - the link existing in "My Network Places" and created while having the previous FW (PV73200_v7.3.6.r3582_European - existing when I bought the POHD) -> it reports "The network path was not found"

I have Microsoft Windows XP [Version 5.1.2600] - these 5 steps were working with PV73200_v7.3.6.r3582_European.

@adrhc

Try this link in IE file://playonhd/usb1/ if this don´t work, try rebooting your router.

Br.
Nasua

I have no router, my PC is connected directly to POHD using a network wire.
I did the following:
1) POHD's static ip is 10.0.0.2:
2) I opened a IE window then tried (unsuccessfully):

file://playonhd/usb1/
file://playonhd/
file://10.0.0.2/usb1/
file://10.0.0.2/
\\10.0.0.2\

Again please notice that I can copy files from my PC using POHD's copy function.
Any other idea ?

Oh no! I've just ordered one of these to replace my Hisense MP800H that cripples the HDMI CEC on my AV setup (Onkyo TX-SR508, Sky+ HD, Panasonic Viera TX-L42D25B).

Do I need to cancel my order?

Is this a firmware issue or a hardware issue ?

If this is a firmware issue when can we expect a fix? This is a MAJOR fault.

I really don't want to be modifying HDMI cables.

I look forward to some good news.

Thx guys.

This update mad my DTS-HDMaster Work.
Same setup as earlier so finally i can make use of my homecinema

You should cancel your order because it seems like ACRyan does not care to fix this.

setup->screen size->adjust red rectangle (doesnt show screen res) = setting this red rectangle to the every edge of the screen calibrates the zoom function (fill/fit/stretch) for video playback

Can anyone comment on this please?

A tip on on the 'Hardware not known, cannot function' message.
I noticed that when the SPDIF cable is unplugged it will start without that message, but with the cable plugged in, it will generate the 'hardware not known' message.
Did anyone else also notice this?

This may help the developers to solve this specific problem.

thanks will tell development

others experience the same and with unplugging the sdpif the message is gone?